top of page
Search
  • Editor

3D printing tall panels with geopolymer

We have managed to 3D print one more 3-meter-long panel. It has at the same time the role of a lintel and a base for the ceiling. Accordingly, we have installed reinforcements in the bottom and the top parts. We have printed the protection layers for the reinforcement. As we are going to fill the inner part with thermal insulation we will get full reinforcement protection. According to the engineering calculations, this should be enough for our little house. In general, the process goes smoother and our interference is needed less and less. There are several stages of automatization ahead.




5 views0 comments

Recent Posts

See All

Comments


bottom of page